[PDF] Modeling Three Dimensional Groundwater Flow And Advective Contaminant Transport At A Heterogeneous Mountainous Site In Support Of Remediation Strategy eBook

Author :
Publisher :
Page : 34 pages
File Size : 44,17 MB
Release : 2004
Category :
ISBN :

GET BOOK

A calibrated groundwater flow model for a contaminated site can provide substantial information for assessing and improving hydraulic measures implemented for remediation. A three-dimensional transient groundwater flow model was developed for a contaminated mountainous site, at which interim corrective measures were initiated to limit further spreading of contaminants. This flow model accounts for complex geologic units that vary considerably in thickness, slope, and hydrogeologic properties, as well as large seasonal fluctuations of the groundwater table and flow rates. Other significant factors are local recharge from leaking underground storm drains and recharge from steep uphill areas. The zonation method was employed to account for the clustering of high and low hydraulic conductivities measured in a geologic unit. A composite model was used to represent the bulk effect of thin layers of relatively high hydraulic conductivity found within bedrock of otherwise low conductivity. The inverse simulator ITOUGH2 was used to calibrate the model for the distribution of rock properties. The model was initially calibrated using data collected between 1994 and 1996. To check the validity of the model, it was subsequently applied to predicting groundwater level fluctuation and groundwater flux between 1996 and 1998. Comparison of simulated and measured data demonstrated that the model is capable of predicting the complex flow reasonably well. Advective transport was approximated using pathways of particles originating from source areas of the plumes. The advective transport approximation was in good agreement with the trend of contaminant plumes observed over the years. The validated model was then refined to focus on a subsection of the large system. The refined model was subsequently used to assess the efficiency of hydraulic measures implemented for remediation.

Author : Jacob Bear
Publisher : Springer Science & Business Media
Page : 851 pages
File Size : 27,76 MB
Release : 2010-01-18
Category : Science
ISBN : 1402066821

GET BOOK

In many parts of the world, groundwater resources are under increasing threat from growing demands, wasteful use, and contamination. To face the challenge, good planning and management practices are needed. A key to the management of groundwater is the ability to model the movement of fluids and contaminants in the subsurface. The purpose of this book is to construct conceptual and mathematical models that can provide the information required for making decisions associated with the management of groundwater resources, and the remediation of contaminated aquifers. The basic approach of this book is to accurately describe the underlying physics of groundwater flow and solute transport in heterogeneous porous media, starting at the microscopic level, and to rigorously derive their mathematical representation at the macroscopic levels. The well-posed, macroscopic mathematical models are formulated for saturated, single phase flow, as well as for unsaturated and multiphase flow, and for the transport of single and multiple chemical species. Numerical models are presented and computer codes are reviewed, as tools for solving the models. The problem of seawater intrusion into coastal aquifers is examined and modeled. The issues of uncertainty in model input data and output are addressed. The book concludes with a chapter on the management of groundwater resources. Although one of the main objectives of this book is to construct mathematical models, the amount of mathematics required is kept minimal.

Author :
Publisher :
Page : pages
File Size : 46,58 MB
Release : 2007
Category :
ISBN :

GET BOOK

A sub-regional scale, three-dimensional flow model of the Snake River Plain Aquifer was developed to support remediation decisions for Waste Area Group 10, Operable Unit 10 08 at the Idaho National Laboratory (INL) Site. This model has been calibrated primarily to water levels and secondarily to groundwater velocities interpreted from stable isotope disequilibrium studies and the movement of anthropogenic contaminants in the aquifer from facilities at the INL. The three-dimensional flow model described in this report is one step in the process of constructing a fully three-dimensional groundwater flow and contaminant transport model as prescribed in the Idaho National Engineering and Environmental Laboratory Operable Unit 10-08 Sitewide Groundwater Model Work Plan. An updated three-dimensional hydrogeologic conceptual model is presented along with the geologic basis for the conceptual model. Sediment-dominated three-dimensional volumes were used to represent the geology and constrain groundwater flow as part of the conceptual model. Hydrological, geochemical, and geological data were summarized and evaluated to infer aquifer behavior. A primary observation from development and evaluation of the conceptual model was that relative to flow on a regional scale, the aquifer can be treated with steady-state conditions. Boundary conditions developed for the three-dimensional flow model are presented along with inverse simulations that estimate parameterization of hydraulic conductivity. Inverse simulations were performed using the pilot-point method to estimate permeability distributions. Thermal modeling at the regional aquifer scale and at the sub-regional scale using the inverted permeabilities is presented to corroborate the results of the flow model. The results from the flow model show good agreement with simulated and observed water levels almost always within 1 meter. Simulated velocities show generally good agreement with some discrepancies in an interpreted low-velocity region near the toe of the Arco Hills. This discrepancy persisted in each of the aquifer bottom thickness scenarios that were simulated precluding decisions on which aquifer bottom thickness to use in transport simulations. When joint-calibration was performed using both water levels and velocities assigned as calibration targets, the discrepancy was prevented. This result highlighted the need to consider multiple calibration objectives and not rely solely on calibration to water levels. The next and last step in the process of constructing a fully three-dimensional groundwater flow and contaminant transport model will be calibration directly to transport from facilities. This last step will likely require further modification of the velocity fields resulting from the three-dimensional groundwater flow model presented in this report.

Author : Mark Goltz
Publisher : John Wiley & Sons
Page : 272 pages
File Size : 31,67 MB
Release : 2017-02-28
Category : Science
ISBN : 0470242345

GET BOOK

Teaches, using simple analytical models how physical, chemical, and biological processes in the subsurface affect contaminant transport Uses simple analytical models to demonstrate the impact of subsurface processes on the fate and transport of groundwater contaminants Includes downloadable modeling tool that provides easily understood graphical output for over thirty models Modeling tool and book are integrated to facilitate reader understanding Collects analytical solutions from many sources into a single volume and, for the interested reader, shows how these solutions are derived from the governing model equations

Author : Karlheinz Spitz
Publisher : Wiley-Interscience
Page : 488 pages
File Size : 25,52 MB
Release : 1996-04-12
Category : Science
ISBN :

GET BOOK

Focusing on modeling applications, this outstanding reference provides a step-by-step, non-mathematical approach to constructing and using realistic workable groundwater models on a daily basis. Extensive detailed drawings, case studies, practical examples, and sample models illustrate important concepts. Includes data on hydrogeologic features and pollutants plus a glossary of terms.

Author :
Publisher :
Page : pages
File Size : 44,80 MB
Release : 1987
Category :
ISBN :

GET BOOK

Modeling of transport in the environmental media was performed. Predicting the future performance of any waste site or facility and postulated actions in terms of migration of potential hazardous materials requires mathematical models capable of simulating flow and transport in the groundwater. Three-dimensional groundwater flow and transport models were developed to simulate the groundwater movement and contaminant transport in the Raw Materials Fabrication Area and the Separations Area. The overall objective of the analysis was to develop groundwater flow models that quantifies the rate and direction of the groundwater movement from the waste sites to points of discharge. The USGS Modular 3D model uses the strongly implicit procedure to solve sets of simultaneous finite-difference equations that represent the groundwater flow process. The transport functions, which are the concentration or mass flux at time t due to continuous injection starting at time t', were obtained by solving the three-dimensional advection-dispersion equations using the Sandia Waste Isolation Flow and Transport (SWIFT) model. 5 refs., 7 figs., 2 tabs.

Author : Ne-Zheng Sun
Publisher : Springer Science & Business Media
Page : 391 pages
File Size : 14,51 MB
Release : 2014-07-08
Category : Technology & Engineering
ISBN : 1475725582

GET BOOK

Groundwater is one of the most important resources in the world. In many areas, water supplies for industrial, domestic, and agricultural uses are de pendent on groundwater. As an "open" system, groundwater may exchange mass and energy with its neighboring systems (soil, air, and surface water) through adsorption, ion-exchange, infiltration, evaporation, inflow, outflow, and other exchange forms. Consequently, both the quantity and quality of groundwater may vary with environmental changes and human activities. Due to population growth, and industrial and agricultural development, more and more groundwater is extracted, especially in arid areas. If the groundwater management problem is not seriously considered, over extraction may lead to groundwater mining, salt water intrusion, and land subsidence. In fact, the quality of groundwater is gradually deteriorating throughout the world. The problem of groundwater pollution has appeared, not only in developed countries, but also in developing countries. Ground water pollution is a serious environmental problem that may damage human health, destroy the ecosystem, and cause water shortage.